ENOMAKER Replacement Carbon Filters Activated Charcoal Block Parts Resin Air Purifier Charcoal Cube Ultra-Absorption Honeycomb for ELEGOO Anycubic Mini Air Filter LCD DLP Resin 3D Printer(Pack of 6)

As the title says, it's a solid replacement, but it is too wide and tall to fit properly into the Anycubic Airpure. If you take off one edge, the width problem is solved, but the cover will be sitting snugly on top of the carbon filter. It works though, so I'm not complaining.

I got two of the mini-air filter units to place next to the 3D printer that I am using at the time. The OEM charcoal filters have proved to be quite fragile. I dropped one of the units and the filter shattered! Getting multiple filters at once is needed by my clumsy self. The filters came very well packed and are perfect replacements! I look forward to using them!

good filters for 3d printers not expensive

For the Anycubic filter, and it is quite a mess to trim them to get them to fit. I won't buy them again.

They were a great value

They fit just fine in the Elegoo USB filter and seem to work as well. We'll see if they last as long as the OEM carbon blocks.

Tried to put it in and it fit way right an it was also to tall so I couldn't get the cap on. I don't know about the any cubic but this is 100% false adversising

These are the same size as the ones that came with the anycubic filter, but they have sides that bulge/aren't completely straight. I had to shave off some of the middle part of the side to get them to fit. Because they are also fairly brittle, this didn't go all that well. Two stars because they did fit eventually, but it took a bit of work.

They are slightly too big and disintegrate when you try and put them in there awefull, ruined the fan as bits fell down into fan after putting top on, avoid at all cost, packaging was not elegoo but wrapped in paper then foam. Just awefull. Stay away from these.